Assembly - Joerns EasyCare Bed User & Service Manual

Joerns® Bed Frames
EasyCare®

Assembly

Caution: Prior to operation, refer to operating
conditions above to ensure bed electronics are within
ambient temperature.
Installation Of Head and Foot Panels
Refer to Bed Panel Installation Sheet for more
Tools required: #2 Phillips screwdriver
Head Panel Installation:
1. Locate the head panel; the head panel has a label
on the back.
2. Lay panel on a flat soft surface, face down, with the
threaded t-nuts facing away from the bed occupant.
3. Head panel brackets have rubber bumpers
mounted on them.
4. The panel brackets are right-left oriented. Items
welded to the side of the panel mounting tube
should be placed to the inside (Figure 1). Install
head panel brackets with four screws provided. Do
not tighten at this time.
5. Insert the brackets into the bed frame sockets
(Figure 2); maintain support of the bed panel.
Insert the safety pins on each side and latch them
(Figure 3).
6. Press the mounting bracket against the bed frame
and tighten the four panel mounting screws; right
and left side.
Foot Panel Installation:
1. Locate the foot panel; the foot panel does not have
a label on the back.
2. Lay panel on a flat soft surface, face down, with the
threaded t-nuts facing towards the bed occupant.
3. The panel brackets are right-left oriented. Items
welded to the side of the panel mounting tube
should be placed to the inside (Figure 4). Install
foot panel brackets with four screws provided. Do
not tighten at this time.
4. Insert the brackets into the bed sockets (Figure 5);
maintain support of the bed panel. Insert the safety
pins on each side and latch them (Figure 6).
5. Press the mounting bracket against the bed frame
and tighten the four panel mounting screws; right
and left side.
Caution: Carefully remove the packaging straps
(orange zip ties) before attempting to operate the bed.
6
©2023 Joerns Healthcare • 6110444 RevA • 000547
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6