Chassis Drain Plumbing; Water Solenoid And Shut-Off Valve - Follett Horizon Elite HCF1412R Operation And Service Manual

Chassis drain plumbing

§ Plug must be removed from John Guest fitting.
§ Route 3/8" drain tubing through knockout in back of docking station and insert fully into John Guest fitting
connection at the rear of the machine chassis. Route other end of 3/8" drain tubing to drain.
§ Drain must slope 1/4" inch per foot (6 mm per 30,4 cm).

Water Solenoid and Shut-off Valve

Standard Installations
Mount water solenoid to inside rear of docking assembly using one screw
➋
,insert tubing into push-in connection of water solenoid
Mount water
solenoid
ATTENTION INSTALLER!
For undercounter installations only, the water inlet solenoid must be mounted on top of the evaporator
connected to the water shut-off valve
of installation provides access to the water shut-off valve for service or in case of an emergency.
2
1
Top of Evaporator
6
➊
➋
, and the potable water line connected to the shut-off valve
3
➊ , insert potable water line into valve
➌
.
➋
➌
➊
, its tubing
➌
. This method
HCF1412R, HCF1412K