Specifications; Electrical; Plumbing; Clearance And Access Information - Follett Ice Pro EDB650 Installation, Operation And Service Manual

Specifications

Electrical

DB650 – The Ice Pro DB650 dispenser requires a separate electrical circuit from the icemaker. Equipment
ground required. Standard electrical - 220V, 60Hz, 1 phase, maximum fuse – 5 amps, 15 amp circuit, NEMA
6-15 receptacle. The cord length is approximately 7' (2.1 m) from right rear. A plug is provided.
EDB650 – The Ice Pro DB650 dispenser requires a separate electrical circuit from the icemaker.
Equipment ground required. Standard electrical - 230V, 50Hz, 1 phase, maximum fuse – 5 amps, 15 amp circuit,
max power - 3450 watts. The cord length is approximately 7' (2.1 m) from right rear. A plug is not provided.

Plumbing

Drain 1" PVC FPT for bin drain – run to floor drain.
Note: Drains should be hard-piped and insulated. Maintain at least 1/4" per foot (1 cm per 48 cm run) slope
on drain line run. Do not tee into icemaker drain line.

Clearance and access information

Door entry – Installation sites must have an unobstructed path to installation location with door openings no
less than 34.5" (877 mm).
Service clearance – A minimum of 12" (305 mm) to right of unit is necessary for service.

Ice type

Dispenser can accommodate most cube/cubelet ice up to 1" square as well as Follett Horizon™ Chewblet ice.
Crushed, flake, or other manufacturers nugget ice cannot be used. Use of these ice types can jam dispenser
and will void warranty. For questions about ice compatibility, call Follett's technical service group toll free at
(877) 612-5086 or +1 (610) 252-7301.

Icemaker weight limit

Icemaker mounted directly on top of bin must not exceed 800 lbs (363 kg).

Environment

Intended for indoor use only - operating temperature range of 40 - 100 F (4 – 38 C). Not suitable for installation
in an area where a water jet could be used. (The dispenser should not be cleaned with a water jet or be
exposed to water jet used to clean surrounding areas.) The dispenser has to be placed in a horizontal position.
The dispenser is only to be installed in locations where it can be overseen by trained personnel.

Container sizes

Unit accommodates bag sizes up to 20 lbs (9 kg) / 27.35" (695 mm) high.
Dispense chute compatible with carts and containers up to 28" (712 mm) high.

Bag pins

Bag pins may be adjusted to accommodate bag hole centers from 5" (127 mm) to 10" (254 mm).
4