Table of Contents
Advertisement
68012005050-FY
Legal and Compliance Statements
2. This device must accept any interference received, including interference that may cause undesired
operation.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
●
Reorient or relocate the receiving antenna.
●
Increase the separation between the equipment and receiver.
●
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
●
Consult the dealer or an experienced radio or TV technician for help.
Important Safety Information
RF Energy Exposure and Product Safety Guide for Portable Two-Way Radios
ATTENTION:
This radio is restricted to Occupational use only.
Before using the radio, read the RF Energy Exposure and Product Safety Guide for Portable Two-
Way Radios which contains important operating instructions for safe usage and RF energy
awareness and control for Compliance with applicable standards and Regulations.
For a list of Motorola Solutions-approved antennas, batteries, and other accessories, visit the following
website:
https://www.motorolasolutions.com
Under Innovation, Science, and Economic Development Canada (ISED) regulations, this radio transmitter
may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter
by ISED. To reduce potential radio interference to other users, the antenna type and its gain should be so
chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful
communication.
This radio transmitter is approved by ISED to operate with a Motorola Solutions-approved antenna with the
maximum permissible gain and required antenna impedance for each antenna type indicated. Antenna types
not included in this list, having a gain greater than the maximum gain indicated for that type, are strictly
prohibited for use with this device.
Notice to Users (FCC and Innovation, Science, and
Economic Development Canada (ISED))
This device complies with Part 15 of the FCC rules and Innovation, Science, and Economic Development
Canada's license-exempt RSS's per the following conditions:
●
This device may not cause harmful interference.
●
The device must accept any interference received, including interference that may cause undesired
operation.
80
Advertisement
Table of Contents
