Mounting In A 19-Inch Rack With An Additional Box Type Rhgs - ABB ProtectIT REL 551 2.5 Installation And Commissioning Manual

2.2
Mounting the terminal
Procedure
1. Carefully fasten the mounting angles to the sides of the terminal.
Use the TORX T20 screws available in the mounting kit.
2. Place the terminal assembly in the rack.
3. Fasten the mounting angles with appropriate screws.

Mounting in a 19-inch rack with an additional box type RHGS

Make sure a side-by-side mounting kit and a suitable 19-inch rack mounting kit are available
before proceeding.
Assemble the two terminals by using a side-by-side mounting kit. Then mount the brackets and
install the assembled terminals in the rack as described in
rack".
xx03000028.vsd
PosNo Description
1 Side-by-side mounting plate
2 Screws (TORX T20)
3 Mounting angle
Figure 2: Side-by-side assembly
Procedure
1. Place the two terminals next to each other on a flat surface.
2
1
3
Chapter 5
Installing the terminal
section 2.1 "Mounting in a 19-inch
27