Table of Contents
Advertisement
To reduce the risk of tipping the appliance, it
must be secured by properly installed anti-tip
device packed with the appliance.
• A child or adult can tip the freestanding cooker and
be killed.
• Install the anti-tip device to the structure by fastening
the supplied bracket to the floor and wall following
the instructions for installing the anti-tip device.
• Engage the anti-tip device.
• Re-engage the anti-tip device if the freestanding
cooker is moved.
All freestanding cookers must have an anti-tip device correctly installed as per the following
instructions. If you pull the freestanding cooker out from the wall for any reason, make sure that
the device is properly engaged when you push the freestanding cooker back against the wall. If
it is not, there is a risk of the freestanding cooker tipping over and causing injury if you or a child
stand, sit or lean on an open oven door.
Instructions are provided for wood and concrete floors. Any other type of construction may
require special installation techniques as deemed necessary to provide adequate fastening of the
Anti-tip bracket to the floor and wall. The use of this bracket does not preclude tipping of the
freestanding cooker when not properly installed.
Wood substrate
1 Place the bracket against the back wall,
into the right rear corner where
the freestanding cooker is to be located.
Leave a 13mm gap between the wall (or
side of freestanding cooker) and the
bracket, as shown.
2 Drill 3.2mm diameter pilot holes in the
center of the two small holes. A nail or
awl may be used if a drill is not available.
3 Fasten the bracket securely to the
floor and wall.
Once installed
Check for proper installation of the freestanding cooker and Anti-tip bracket by grasping the back
of the freestanding cooker and carefully attempting to tilt it forward.
INSTALLING THE ANTI-TIP BRACKET
WARNING!
Concrete or cement substrate
1 Locate the bracket as shown.
2 Using the bracket as a template, drill
(x2) 8mm diameter pilot holes in the
center of the larger holes to a depth of
at least 45mm.
3 Place the sleeve anchors into the
holes and use a hammer to tap them
all the way in.
4 Tighten the nuts on the sleeve anchors to
fasten the bracket securely to the floor.
Locating the bracket
13mm
Wood
Concrete
Securing the freestanding cooker
Right rear foot
slides under bracket
15
Advertisement
Table of Contents
