Table of Contents
Advertisement
IMPORTANT!
The power supply cable must be connected by a Fisher & Paykel trained and support
service technician or qualified person.
Power supply cable section
Use a type of cable according to the applicable local regulations.
single-phase connection illustrated
ELECTRICAL FEEDER CABLE CONNECTION
1 Remove the two screws that hold the rear
access panel in place at the back of the
cooker and set aside.
2 Loosen the strain relief using two spanners
and feed through power supply cable.
IMPORTANT!
Do not to unscrew the strain relief from
the cooker.
3 Connect the live neutral and earth cables
to the terminal block. Lock the strain relief
tight on the power supply cable screw the
rear access panel back in place.
IMPORTANT!
The earth conductor should remain
around 30mm longer than the others.
SINGLE-PHASE CONNECTION
J1
J2
2
4
1
3
5
L
N PE
TWO-PHASE CONNECTION
J2
Remove J1
2
4
1
3
5
L2
L1
N PE
THREE-PHASE CONNECTION
Remove J1 and J2
2
4
1
3
5
L3 L2
L1
N PE
13
Advertisement
Table of Contents
