Advertisement
Quick Links
Care and cleaning
Always turn off the oven at the wall first. Ensure the oven has cooled down completely before starting.
• Before you start cleaning your cooker, please:
• Read these cleaning instructions and the 'Safety and warnings' section at the start of this user
• Turn the cooker off at the wall.
• Make sure the cooker is a safe temperature to touch.
• Do not use a steam cleaner.
• Do not keep flammable substances in the oven.
General advice
• Wipe down the cooktop and wipe out the oven after every use.
• Wipe up spills. Avoid leaving alkaline or acidic substances (such as lemon juice or vinegar) on the surfaces.
• Do not use cleaning products with a chlorine or acidic base (ie citrus-based cleaners).
Cleaning the outside of the cooker
• Do not use abrasive cleaners, cloths or pads on the outside surfaces.
• Immediately wipe off any caustic cleaners if they are spilled onto the oven door handle.
Wipe the outside surfaces often, using warm water and a mild household detergent. The stainless steel may also be
cleaned with a suitable cleaner and polish.
https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Induction/OR90SDBSIX2/User_Guide_OR90SDBSIX2/1...
guide.
Updated: Fri, 21 Aug 2020 14:54:17 GMT
Powered by
1
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Fisher & Paykel OR90SDBSIX2
Summary of Contents for Fisher & Paykel OR90SDBSIX2
- Page 1 • Immediately wipe off any caustic cleaners if they are spilled onto the oven door handle. Wipe the outside surfaces often, using warm water and a mild household detergent. The stainless steel may also be cleaned with a suitable cleaner and polish. https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Induction/OR90SDBSIX2/User_Guide_OR90SDBSIX2/1… Updated: Fri, 21 Aug 2020 14:54:17 GMT Powered by...
-
Page 2: Caring For Your Cooktop
1. Turn the element off and carefully scrape the spill to a cool area of the cooktop surface. 2. Clean the spill up with a cloth or paper towel. 3. As soon as the cooktop is cool enough to safely touch, clean with cooktop cleaner. https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Induction/OR90SDBSIX2/User_Guide_OR90SDBSIX2/1… Updated: Fri, 21 Aug 2020 14:54:17 GMT Powered by... - Page 3 • When you have finished cleaning the oven ceiling, raise the grill element and screw the element fixing screws back onto the studs. Make sure that the fixing screws are tightened and the element is held securely in place. The grill element itself is self-cleaning. https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Induction/OR90SDBSIX2/User_Guide_OR90SDBSIX2/1… Updated: Fri, 21 Aug 2020 14:54:17 GMT Powered by...
- Page 4 30 minutes. Rinse the filter in clean water and dry. Fig. 28 Fat filter Cleaning the grill tray and shelves Clean these in hot, soapy water. https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Induction/OR90SDBSIX2/User_Guide_OR90SDBSIX2/1… Updated: Fri, 21 Aug 2020 14:54:17 GMT Powered by...
- Page 5 • the side racks • the slides to the top wire of a shelf position • both sides of each pair of slides • both slides on the same level. https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Induction/OR90SDBSIX2/User_Guide_OR90SDBSIX2/1… Updated: Fri, 21 Aug 2020 14:54:17 GMT Powered by...
-
Page 6: Storage Drawer
• The drawer opens like a normal drawer. The drawer slides stop if from sliding all the way out. To remove the drawer 1. Open the drawer fully 2. Press the lever on the left guide rail down and the right guide rail up https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Induction/OR90SDBSIX2/User_Guide_OR90SDBSIX2/1… Updated: Fri, 21 Aug 2020 14:54:17 GMT Powered by... - Page 7 Fisher & Paykel dealer and follow these steps. Oven bulb replacement is not covered by your warranty. 1. Allow the oven to cool down, then turn it off at the mains power supply (wall switch). https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Induction/OR90SDBSIX2/User_Guide_OR90SDBSIX2/1… Updated: Fri, 21 Aug 2020 14:54:17 GMT Powered by...
- Page 8 3. Using a flat-head screwdriver, twist and lift the retainer clip upwards to release the glass cover. Hold the glass cover to prevent it falling. 4. Carefully lift the glass cover out of the retaining bracket in the back and pull out the faulty bulb. https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Induction/OR90SDBSIX2/User_Guide_OR90SDBSIX2/1… Updated: Fri, 21 Aug 2020 14:54:17 GMT Powered by...
- Page 9 (wall switch). Removing and replacing the door glass panes for cleaning. Make sure you follow the precautions and instructions below very carefully. Replacing the glass panes and the door https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Induction/OR90SDBSIX2/User_Guide_OR90SDBSIX2/1… Updated: Fri, 21 Aug 2020 14:54:17 GMT Powered by...
-
Page 10: Removing The Door
1. Turn the oven off at the wall. Make sure you have prepared enough space for resting the door and its glass panes on a clean, flat surface. Open the door to its full extent. https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Induction/OR90SDBSIX2/User_Guide_OR90SDBSIX2/1… Updated: Fri, 21 Aug 2020 14:54:17 GMT... - Page 11 2. Open the levers on the left and right hinges to their full extent, as shown. 3. Gently close the door until the left and right hinge levers are hooked to the door. https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Induction/OR90SDBSIX2/User_Guide_OR90SDBSIX2/1… Updated: Fri, 21 Aug 2020 14:54:17 GMT...
- Page 12 5. Lift the door and disengage the hinges. Rest the door on a soft surface. Ensure you lay it with the handle side down. Remove the inner and middle glass pane 1. Press down on both tabs (1) to release the glass retainer (2). https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Induction/OR90SDBSIX2/User_Guide_OR90SDBSIX2/1… Updated: Fri, 21 Aug 2020 14:54:17 GMT Powered by...
- Page 13 2. Lift the inner pane (C) slightly (1), then gently slide out (2). 3. Slide the middle pane (B) slightly towards yourself (1), then lift (2) and slide out (3). https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Induction/OR90SDBSIX2/User_Guide_OR90SDBSIX2/1… Updated: Fri, 21 Aug 2020 14:54:17 GMT Powered by...
- Page 14 2. Insert the pane into the middle pair of grooves (1), push it slightly towards yourself (2) and gently lower into place (3). Use the middle pair of grooves. The pair of grooves closest to the outer pane must remain empty. https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Induction/OR90SDBSIX2/User_Guide_OR90SDBSIX2/1… Updated: Fri, 21 Aug 2020 14:54:17 GMT Powered by...
- Page 15 It has to be in this position for the door to function correctly. Check that the gasket (D) is in place. It should sit on the inner pane of glass in the centre as shown. https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Induction/OR90SDBSIX2/User_Guide_OR90SDBSIX2/1… Updated: Fri, 21 Aug 2020 14:54:17 GMT Powered by...
- Page 16 5. Gently push the glass retainer back into place. You should be able to hear the tabs on both sides click as they lock the glass retainer in. Make sure the glass retainer is correctly and firmly in place and that the glass panes are secure. https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Induction/OR90SDBSIX2/User_Guide_OR90SDBSIX2/1… Updated: Fri, 21 Aug 2020 14:54:17 GMT Powered by...
- Page 17 Refit the door 2. Insert the hinge tongues into the slots, making sure that the notches on both sides drop into place as shown. 1. Hold the door firmly https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Induction/OR90SDBSIX2/User_Guide_OR90SDBSIX2/1… Updated: Fri, 21 Aug 2020 14:54:17 GMT Powered by...
- Page 18 4. Fully close the levers on the left and right hinges, as shown. Close the door, turn the power supply to 3. Open the door to its full extent. the oven on at the wall. https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Induction/OR90SDBSIX2/User_Guide_OR90SDBSIX2/1… Updated: Fri, 21 Aug 2020 14:54:17 GMT Powered by...
Need help?
Do you have a question about the OR90SDBSIX2 and is the answer not in the manual?
Questions and answers