Table of Contents
Advertisement
Fitting the anti-tilt bracket
To restrain the appliance and prevent it tipping accidentally, the antitilt bracket and restraining plate
supplied must be fitted according to the instructions below.
1. Drill four 8mm diameter holes for the fixing screws (two in the wall and two in the floor-see Fig.4) and insert the
plastic plugs supplied.
Fig. 4 Attaching the anti-tilt bracket and sliding the cooker into place
Before drilling the holes, check that you will not damage any pipes or electrical wires.
2. Attach the anti-tilt bracket to the floor and rear wall using the four screws supplied, as shown in Fig. 4.
3. After attaching the anti-tilt bracket securely, slide the cooker into place. Ensure that the left rear foot slides
under the bracket, as shown in Fig.4.
4. Access the bracket by removing the drawer (Fig. 5):
https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Induction/OR90SDBSIX2/User_Guide_OR90SDBSIX2/02_Installatio
Updated: Fri, 08 Mar 2019 10:03:53 GMT
Powered by
5
Advertisement
Table of Contents
