DISPLAYCOBTRWDDY2
7
- 2 - INSTALLATION
2.1 MOUNTING
DISPLAYCOBTRWDDY2 is designed for applications in exhibition areas, commercial spaces, museums, res-
taurant, churches, and any other installation where size is an important factor. For fixing, stable mounting
clips are required. The mounting place must be of sufficient stability and be able to support a weight of
10 times of the unit's weight.
When carrying out any installation, always comply scrupulously with all the regulations (particularly re-
garding safety) currently in force in the country in which the fixture's being used.
• Install the projector at a suitable location.
• Always additionally secure the projector with the safety rope from falling down. For this purpose, fas-
ten the safety rope at a suitable position so that the maximum fall of the projector will be 20 cm.
• Adjust the projector and use the knobs.
NOTE - For the installation of the DISPLAYCOBTRWDDY2 make sure that the ridge of the adaptor is in with
the groove of the track. Turn knobs 90° to connect the adaptor to the circuit. Please see the below instruc-
tions.
1
2
3
Fig.3