Setting The 4G Module And Cloud Nms - Huawei EN83CTLA User Manual

EN83CTLA SNMP Card
User Manual
● Mailbox Address in Alarm Notification can be selected only after it is added
● If you enable alarm notification by email, when there is an alarm, the system
● Alarm sending example: If the SNMP card is powered on between 6:00 and
Step 5 Click Test to check whether the added mobile number is available. If it is available,
Successfully sent the test short message. is displayed.
If the message Test email sending failed is displayed, check whether the parameters of the
recipient mailbox are correct.
----End

5.4 Setting the 4G Module and Cloud NMS

Prerequisites
1.
Procedure
Step 1 Log in to the WebUI. For details, see
Step 2 Choose Monitoring > Wireless Module > Running Parameter > Basic
Parameters, and set Mobile data to Enable.
Issue 04 (2024-01-30)
NO TICE
in Mailbox Settings.
will send emails to the receiver at 00:00, 06:00, 12:00, and 18:00. If the SNMP
card is powered on within one hour after any of those four time points, the
system will check whether the alarm notification has been sent at the previous
time point after power-on. If the notification has not been sent, the system will
send it. If the notification has been sent, the system will not send it again. If
the SNMP card is powered on more than one hour after any of those four time
points, the alarm notification will not be sent until reaching the next time
point.
6:59, the system will check whether the alarm notification has been sent at
6:00. If it has been sent, the system will not send it again. If it has not been
sent, the SNMP card will send it. If the SNMP card is powered on between 7:00
and 11:59, the alarm notification will not be sent until 12:00.
NO TE
Cables have been connected to the 4G module.
Figure 5-8 Installing a 4G module
Copyright © Huawei Digital Power Technologies Co., Ltd.
4.1 Logging In to the
5 Device Commissioning
WebUI.
38