Table of Contents
Advertisement
Installing Harness System
53
If the harness straps have been removed from the splitter plate,
and if the buckle tongues and chest clip have been unthreaded,
follow the steps below to rethread them.
1
Thread Buckle and Chest Clip
The harness strap ends go through
the back of the buckle tongues and
through the chest clip front to back
as shown.
2
Thread Harness Straps into
Shoulder Harness Slot
3
Attach Harness Strap Loops to
Splitter Plate As Shown
The sewn ends of the harness strap
loops must face towards you.
Do not twist the harness strap or the
harness adjustment strap.
Make sure the harness strap loops
are fitted completely on both sides
of the splitter plate.
sewn
end
Check your child's fit often. To learn how to check harness
tightness, see pages 46-48.
Check the harness straps often for any wear or damage.
The harness system must be installed correctly. The
harness straps on this car seat are not
replaceable. Do not fully remove the harness
straps from the shell. Do not use a child restraint with
damaged harness straps.
Aircraft Information
This restraint is certified for aircraft use.
Install the car seat in a window seat to avoid blocking the aisle. If the
aircraft lap belt is too short, ask the flight attendant for a belt extender.
Use only on forward-facing aircraft seats.
Contact the airline for their specific policies.
Some airlines may ask to see a label stating
that this car seat is certified for aircraft use.
There is an airplane certification label
located on the side of this car seat as
shown.
Store the lower anchor belt and tether strap when
installing with aircraft belts.
Rear-Facing Aircraft Installation
Follow the steps on pages 25-29.
Forward-Facing Aircraft Installation
Follow the steps on pages 37-40, skipping
the tether strap steps.
54
Advertisement
Table of Contents
