Table of Contents
Advertisement
23
When installing in the
Mode
Strap
installed in a vehicle, attach the
tether hook to its storage attachment
on the back of the car seat as shown.
Gently tighten to remove slack.
Adjuster
Storage
Attachment
Tether Storage
Attachment
and Parts
Pull Free End of
Belt to Tighten
To tighten: After the car seat is
locked into place with the lower
anchor belt or vehicle belt, push
down on the car seat and gently pull
on the free end of the tether strap.
To loosen: Lift up on the tether
Lift Adjuster Up to
adjuster and push it towards the
Loosen
tether hook.
Storing Tether Strap
Rear-Facing
or when the car seat is not
Adjusting Tether Strap
Rear-Facing Mode
14-40 lb (6.4-18 kg) and 40 in. (101.6 cm) or less
Lap/Shoulder
Lap Belt
Belt
Never install a rear-facing child restraint in the
front seat of a vehicle equipped with an active
frontal airbag.
Do not use the tether for rear-facing mode. Secure the
tether strap hook to its storage attachment.
Do not use the lower anchor belt along with the vehicle lap
or lap/shoulder belt.
Check the vehicle belt or the lower anchor belt before each
use. Use only if the belt can be tightened properly and
locked securely in place.
Do not fasten multiple lower anchor connectors on the
same lower anchor bar in the vehicle.
Even when unoccupied, this child restraint must be fi rmly
secured to the vehicle with a lower anchor belt or with the
vehicle seat belt.
This child restraint must always face the rear of the
vehicle until the child is at least 1 year old and weighs
22 lb (10 kg).
24
LATCH: Lower
Anchor Belt
Advertisement
Table of Contents
