Sub-Zero 648PRO User Manual page 13

S U B - Z E R O P R O 4 8 U S E & C A R E
I N T E R I O R C L E A N I N G
To clean interior surfaces and removable parts,
wash with a mild solution of soap and luke-
warm water with a little baking soda. Do not
use vinegar. Rinse and dry thoroughly. Avoid
getting water on lights and control panel.
Do not submerge or pour hot water over
cold glass shelves.
E X T E R I O R C L E A N I N G
To clean the exterior stainless steel surfaces of
the PRO 48, use a soft, nonabrasive stainless
steel cleaner like Signature Polish and apply
with a soft, 100% lint-free cloth.
To bring out the natural luster of the stainless
steel, lightly wipe the surface with a water-
dampened microfiber cloth followed by a dry
polishing chamois. All work should follow the
grain direction of the finish. Better results are
obtained by keeping the cloth in continuous
contact with the stainless steel.
Signature Polish is available from Signature
Limited Laboratory, P. O. Box 13436, Dayton,
Ohio 45413-0436, or 877-376-5474 (toll free).
Under no circumstances should you use a
metallic or highly abrasive cleaner or
cloth, as this will scratch the classic
stainless steel finish.
C O N D E N S E R C L E A N I N G
The condenser of the PRO 48 is located behind
the grille at the top of the unit. The grille must
be lifted to access the condenser area for
cleaning. To lift the grille, pull out on the
bottom edge of the grille and tilt the grille
frame forward.
Use a soft bristle brush and vacuum to remove
dust and lint from the condenser. Clean the
condenser area every three to six months.
Failure to clean the condenser could
result in temperature loss or mechanical
failure or damage.
Before cleaning the unit, shut the electric-
ity off at the control panel. When you
clean the condenser, wear gloves to avoid
injury from the sharp condenser fins.
13