Janome Quilt Maker Pro 16 User Manual page 11

User Manual
3. Slide the four bolts into holes un琀椀 l they stop. Hand 琀椀 ghten, and then use the 3 mm wrench to securely
fasten the handles to the back of the machine.
4. A昀琀 er the four bolts are in place, plug the small connector end of the cable into the port on the le昀琀 side
of the display. Push the plug securely into place.
5. Securely plug the other end of the cable into the port on the back of the machine below
the handlebars.
 NOTE: See the instruc琀椀 ons that accompany the Rear Handlebars and Display.
 IMPORTANT: A昀琀 er the rear handlebars have been completely installed and plugged in, test them by
turning on the Quilt Maker Pro 16 and looking at the rear display. If nothing appears on the screen,
check that both the front and rear handlebar cables are plugged in securely, that your machine is
turned on, and that the power cord is plugged into the machine as well as a power source.
16
QUILT MAKER PRO 16
www.janome.com