Performing A Visual Check - tams elektronik SD-34 Manual

SD-34 | SD-34.2

3.6. Performing a visual check

Perform a visual check after the assembly of the decoder and remove faults if necessary:

Remove all loose parts, wire ends or drops of solder from the PCB. Remove all sharp wire
ends.

Check that solder contacts which are close to each other are not unintentionally connected
to each other. Risk of short circuit!

Check that all components are polarised correctly.
When you have remedied all faults, go on to the next part.
14 | Assembling the SD-34 kit
tams elektronik