Distance Between Angle Sensor And Brewer Spindle (Magnet) - WMF 5000 S+ Service Manual

Service
2.2

Distance between angle sensor and brewer spindle (magnet)

The "Brewer in place" status is detected by the angle sensor, which detects the magnet
installed at the upper end of the brewer spindle.
The distance between the angle sensor and the magnet on the brewer spindle must be
between 0.8 and 2.8 mm. This distance is checked during commissioning in the factory.
When it is too low, then spacers are installed to compensate for component tolerances.
When the brewer or brewer screen is replaced, the spacing distance must be checked:

Unscrew the angle sensors.
 Leave the installed state as it is (with or without spacers).
 Check spacing with gage.
 If the gap is greater than 2.8 mm > then remove spacers.
 If the gap is less than 0.8 mm > install spacing shim.
A set of spacers consisting of 2 plates of 0.5 mm and 1 mm thickness is available for
adjusting the spacing.
Item number 33 2908 1000
The set of spacers is included with a spare brewer drive.
Fig. Checking the distance Fig. Gage 33 2695 5000
14