External Drain Hose; Internal Drain Hose - Haier GE PTW600BPR DG Series Technical Service Manual

6. Pull the pump away from the tub. Be sure
the seal comes off with the pump. The seal
comes with a new pump but can be ordered
separately.

External Drain Hose

The external drain hose is used to direct the
water being expelled from the tub by the drain
pump to the house drain or standpipe.
Drain Hose Removal
NOTE: Ensure that the washer tub is empty
before removing the drain hose.
1. Squeeze the spring clamp and slide it up onto
the drain hose part where it clamps to the
drain port and remove the hose.
Drain
Hose
Drain Hose Clamp

Internal Drain Hose

The internal drain hose is used to direct the water
being removed by the drain pump to the external
drain hose.
Internal Drain Hose Removal
NOTE: Ensure the washer tub is empty before
removing the drain hose.
Pump
The internal drain hose clamp can be reached
Seal
two ways; either through the rear access panel,
or by leaning the washer back.
1. Access the rear of the washer and remove the
external drain hose. Have a towel or small
pan ready to catch excess water from the
hose and tub.
2. Remove the hex-head screw securing the
drain port to the access panel.
Screw
3. Push in on the locking tab and slide the drain
port up and to the inside of the cabinet.
4. If it's necessary to remove the access panel,
remove two hex-head screws and slide to the
left side.
Screw
Drain
Port
Screw
– 43 –
Locking
Tab