Table of Contents
Advertisement
Drain Pump
The drain pump is located on the bottom right
side of the tub. It is mounted directly to the
bottom of the tub. The drain pump is a 120
VAC pump used to remove water from the tub
assembly to the house drain. The maximum
drain height that it will pump out to is 8 feet.
Drain Pump Diagnosing
1. Disconnect power to the washer and access
the main board.
2. Disconnect the J401 for 600/605 models and
for other models J512 connector from the
board.
3. Resistance measured across the drain pump
tab terminals with the connector removed
is approximately 13-ohms. Or with the drain
pump harness connector plugged into the
drain pump, measure between pins 2 and 3
of the connector plugged into J512 and AC
power off. When the drain pump is activated,
there will be 120 VAC at the drain pump. If
drain pump is turned off by control, there will
be no AC voltage.
Drain Pump Removal
Before removing the drain, any water in the
basket must be removed. This is done by using a
transfer pump (Part #: WX05X23817).
The transfer pump only comes with one (1) hose.
A standard washer hose can be used for the
outlet side of the pump (Part #: WH41X10207).
Drain System
Pump out as much of the standing water in the
basket as possible. Lean the washer back and
pump out the water seen in the basket.
When the drain pump is removed, approximately
1 to 2 cups of water will drain out of the drain
pump opening in the tub. Have something ready
to catch the excess water left in the tub.
1. Lean the washer back using ergo-assisting
prop blocks (Part #: WX05X10027) or lay the
washer on its side to access the bottom of the
tub.
2. Disconnect the harness connector for the
drain pump.
3. Disconnect the wire tie securing the harness
to the platform assembly. A new wire tie
comes attached to the drain pump harness.
4. Disconnect the internal drain hose from the
drain pump.
5. Remove three hex-head bolts securing the
pump to the tub.
– 42 –
Internal
Drain Hose
(Continued next page)
Advertisement
Table of Contents
