Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for SI Dynamic 2 XL
Summary of Contents for SI Dynamic 2 XL
- Page 1 Installation Manual Dynamic 2 XL Exclusively Distributed by...
- Page 2 It is a requirement of installation that the installer does relevant risk assessments and implements relevant best lifting practices and use of equipment. Every installation if unique and therefore Display Technologies Ltd is unable to advise on the exact installation of each screen/project. Dynamic 2 XL Installation Manual – Revision – 1.0...
- Page 3 The bottom Right part also contains the control panel which is pre-fitted in ships in that part. The 6 parts fit together on the wall to form the screen. The Velvet covers then go over the screen frame to complete the installation. Dynamic 2 XL Installation Manual – Revision – 1.0...
-
Page 4: Installation
Once it is, fix the rest of the side to the wall using appropriate fixings through the inner fixing flange of this section. Dynamic 2 XL Installation Manual – Revision – 1.0... - Page 5 Slide the mask slider along to line up with the mask bar. Next loosen the hex holts in the 2 silver joining pins. Slide up the joining pins into the mask bar. Retighten the hex bolts in both joining pins. Dynamic 2 XL Installation Manual – Revision – 1.0...
- Page 6 Dynamic 2 XL Installation Manual – Revision – 1.0...
- Page 7 Taker the left one out to the top left mask slider and connect the carabiner to the hole in the aluminium of the mask slider. • Repeat the process to tension the top right mask • Repeat for the bottom of the left mask Dynamic 2 XL Installation Manual – Revision – 1.0...
- Page 8 • Repeat for the bottom of the right mask. Dynamic 2 XL Installation Manual – Revision – 1.0...
-
Page 9: Electrical Connections
Simply make these connections ensuring that the plug and sockets are properly connected and locked together. • Ensure that the wiring is not obstructing any moving parts of the screen including the mask sensor wirers. Dynamic 2 XL Installation Manual – Revision – 1.0... - Page 10 The screen is now ready for operation and external RS232 control of operation. The RS232 connection is on the top of the control box and the cable to this can be routed through the right side frame following the power cable routing. Dynamic 2 XL Installation Manual – Revision – 1.0...
- Page 11 It may also be necessary to add one or two black adhesive packers (supplied) to the inside of the top lip of the top covers if they need to be raised in height at all. Dynamic 2 XL Installation Manual – Revision – 1.0...
- Page 12 You may want to try pushing the fabric tool into the fabric retaining track without any fabric first to get a feel for where it goes in and how much force is required. Dynamic 2 XL Installation Manual – Revision – 1.0...
- Page 13 Only tuck max 300mm at a time in each direction and then go to the opposing side and tuck the same amount. This will ensure an even stretch across all the fabric. Dynamic 2 XL Installation Manual – Revision – 1.0...
- Page 14 Ensure that you use the white cotton gloves to handle the white projection fabric at all times and keep it away from dust or dirt as it can easily be marked. Dynamic 2 XL Installation Manual – Revision – 1.0...
Need help?
Do you have a question about the Dynamic 2 XL and is the answer not in the manual?
Questions and answers