Summary of Contents for SI Short Throw Lift Motorized Screen
Page 1
Short Throw Lift Motorized Screen Installation Instructions INSTALLERS: PLEASE LEAVE THIS MANUAL WITH THE OWNER. 400192 | v. 1.1 | 14 August 2023...
Page 2
APPLY S/N STICKER HERE Limited 1 year warranty on Screen Innovations products Screen Innovations warrants its products, to the original purchaser only, to be free from defects in materials and workmanship for a period of one (1) year from the date of purchase by the original purchaser provided they are properly operated according to Screen Innovations' instructions and are not damaged due to improper handling or treatment after shipment from the factory.
STRUCTURAL DIAGRAM Fabric Support Bar Upper Support Arm Connecting Parts Tab Tension Fabric Joint Lower Support Arm Decorative Door End Cap Casing Level Adjustment Knob Side Handle Manual Control Button Flexible Door Opening and Closing Device Power Port 152mm 6” Side View...
SCREEN INSTALLATION GUIDELINES Surface Mount Installation Lay the projection screen flat on the cabinet: leave at least 4mm of room from the wall for the decorative door’s operation. Fully extend the projection screen using the remote, adjust the tilt of the projection screen using the Level Adjustment Nobs under the casing.
Page 7
SCREEN INSTALLATION GUIDELINES Wall Mount Installation a. Measure the total length of the casing and verify there is sufficient clearance and no obstructions on the wall. Measure the height where the bottom of the projection screen will be placed and mark it on the wall. Note: Apply masking tape and make your marks on the tape. Reference your screen size on the below table, and use value “A”...
Page 8
SCREEN INSTALLATION GUIDELINES c. Adjust the T-slot bolt on the Adjustable Bracket so that they are parallel with the wall (see diagram), place the projection screen on the Adjustable Brackets, adjust the projection screen horizontally to the desire position, tighten the T-slot bolt from under the Adjustable Brackets to lock in place.
FUNCTIONS AND INSTRUCTIONS The Short Throw Lift Motorized screen can be controlled by the following methods: a. Manual Control button b. 12v Trigger Control c. RF Remote Control Manual Control The Manual Control Button is located on the power port side of the casing. Pressing the button will command the screen to extend, pressing the button will command the screen to stop, then again to retract, then stop in sequence.
PROGRAM AND OPERATION Infrared Remote The IR Remote is required to set the upper limit and for wireless operation of the screen. 1. Press the up button, the decorative door opens first, and the fabric rises; 2. Press the stop button, the decorative door or fabric will pause; 3.
DECORATIVE DOOR ANTI-PINCH FUNCTION The decorative door of this product is equipped with a flexible door opening and closing device, which can protect hands or objects from accidentally extending into the screen when closing the door. MAINTENANCE Ultra-short throw ambient light rejection fabric: DO NOT USE RAG OR PAPER TOWEL TO WIPE - Use brush provided to brush lightly horizontally along the texture of the screen to remove dust or other fine particles.
Page 12
Screen Innovations 9715-B Burnet Rd, Suite 400 Austin, TX 78758 512.832.6939 www .screeninnovations . c om 400192 | v. 1.1 | 14 August 2023...
Need help?
Do you have a question about the Short Throw Lift Motorized Screen and is the answer not in the manual?
Questions and answers