Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for SI Dynamic 2TB
Summary of Contents for SI Dynamic 2TB
- Page 1 Installation Manual Dynamic 2TB Exclusively Distributed by...
- Page 2 Good lifting practices and lifting aids should be used as required to aid installation. Important Notes The symbols below show important notes that must be read and understood at each stage of installation = Warnings (Safety or Installation Quality) = Information (Installation requirements or tips) Dynamic 2TB Installation Manual – Revision – DRAFT...
- Page 3 Note that the Dynamic 2TB is designed to be assembled on the wall so that a clear floor area big enough to build the screen is not required. However it can also be built on the floor if preferred you will gust need to follow the same instructions but substitute the wall for the floor then lift and attach the screen to the wall once built.
-
Page 4: Installation
Now lift the left section and mate the joining slider into the respective profile until the two ends of the profile meet fully. • Using a spirit level check that the section is vertical. Dynamic 2TB Installation Manual – Revision – DRAFT... - Page 5 Fix the Top section to the Left and Right sections again with the sliders ensuring that you tighten the grub screws and the fixing screws. Only fix through the points marked ’Fixing Point’ and take care with the cable running across the top frame. Dynamic 2TB Installation Manual – Revision – DRAFT...
- Page 6 Ensure that the ends of the two sections meet fully together. • Mechanically you now have all the sections fitted to the wall. Dynamic 2TB Installation Manual – Revision – DRAFT...
- Page 7 Pull the hook towards the mask taking care not to release the hook as it will be under spring tension. Once you have pulled it right the way out to the mask hook the hook onto the small wire loop attached to the mask bar. Dynamic 2TB Installation Manual – Revision – DRAFT...
- Page 8 Alan screw that the covers should sit onto. Ensure that the cover is right back onto the magnets and that the joints are tightly pushed together. Dynamic 2TB Installation Manual – Revision – DRAFT...
- Page 9 You may want to try pushing the fabric tool into the fabric retaining track without any fabric first to get a feel for where it goes in and how much force is required. Dynamic 2TB Installation Manual – Revision – DRAFT...
- Page 10 Only tuck max 300mm at a time in each direction and then go to the opposing side and tuck the same amount. This will ensure an even stretch across all the fabric. Dynamic 2TB Installation Manual – Revision – DRAFT...
- Page 11 Ensure that you use the white cotton gloves to handle the white projection fabric at all times and keep it away from dust or dirt as it can easily be marked. Dynamic 2TB Installation Manual – Revision – DRAFT...
-
Page 12: Front Cover Installation
• To start operation press ‘Home’ this will set the masks to their home position (just covering the edge of the screen surface but showing the full width aspect of the screen). Dynamic 2TB Installation Manual – Revision – DRAFT... - Page 13 This will free it and continue with the initialisation sequence. The screen is now ready for operation and external RS232 control of operation. • Dynamic 2TB Installation Manual – Revision – DRAFT...
Need help?
Do you have a question about the Dynamic 2TB and is the answer not in the manual?
Questions and answers