Siemens SIMATIC ET 200AL System Manual page 76

Connecting
8.7 Wiring
Accessories required for the connection of ET-Connection
You need the following accessories:
• ET-Connection cables
• 4-pin M8 connection plug
NOTE
ET-Connection cables
When connecting ET-Connection use only the offered cables.
Connecting M8 plugs
To connect M8 plugs, proceed as follows:
1. Insert the connector in the appropriate round socket on the module.
2. Tighten the connector using the knurled screw with a torque of 0.4 Nm.
The figure below shows the connection of the M8 plugs, using the example of
the DIQ 4+DQ 4x24VDC/0.5A 8xM8 digital input / digital output module.
Figure 8-9 Connecting M8 plugs
76
Make sure that there is proper locking between the connector and socket.
Distributed I/O system
System Manual, 12/2023, A5E31861578-AL