Siemens SIMATIC ET 200AL System Manual page 104

Commissioning
11.1 PROFINET IO
11.1.1 Commissioning ET 200AL on PROFINET IO
Introduction
The commissioning of your distributed I/O system depends on the system configuration. The
following procedure describes the commissioning of the ET 200AL distributed I/O system on
an IO controller.
Requirements for the ET 200AL distributed I/O system on PROFINET IO
NOTE
Performing tests
You must ensure the safety of your plant. You therefore need to perform a complete
functional test and the necessary safety checks before the final commissioning of a plant.
Also plan the tests to include any possible foreseeable errors. This will allow you to prevent
people or plants from being placed in danger during operation.
Procedure
The following table shows the chapters/documents in which the required actions are
described.
Table 11-1 Requirements for the ET 200AL distributed I/O system on PROFINET IO
Step
1
2
3
104
Procedure
Mounting the ET 200AL interface module
Wiring the ET 200AL interface module
Configuring the ET 200AL interface module Section Configuring (Page 83)
See...
Section Mounting (Page 52)
Section Connecting (Page 57)
Distributed I/O system
System Manual, 12/2023, A5E31861578-AL
11