Table of Contents
Advertisement
SECTION
4
Periodic Inspection and
Maintenance
When daily inpsection checks have been regularly
perfomed, these additional inspections are required
less frequently, approximately every 60 to 80 hours
of operation.
•
Check for loose wiring and tighten connections
if required.
•
Check for loose hardware and tighen as required.
•
Inspect for damaged/broken partsand replace as
needed.
•
Check drive pinions on both the X and Y drive
motors and tighten the setscrews to secure then
to the drive shafts.
•
Inspect the polished round steel rails for pits,
nicks and wear spots. Lightly sand or polish
nicks smooth.
•
When the rails start to wear flat spots, the
setscrews in the rail supports can be loosened
and the round rail rotated and reset in the
support. These rails are hardened but over time
they will wear. See the procedure later in this
section.
Maintenance
Advertisement
Table of Contents
