Infineon XENSIV PAS CO2 Sensor2Go Quick Start Manual page 11

Quick-start guide for XENSIV™ PAS CO2 Sensor2Go
evaluation kit
(ABOC)
Forced compensation:
Force compensation can also be triggered from the popup from figure 9 with the help of the following steps.
1. Configure the "Reference CO2 baseline [ppm]" via the slider box or by typing directly into the text box
2. After changing the baseline value press enter and click the "Apply all settings" button (figure 10)
3. Start the Forced compensation by pressing the "Start Calibration" button
4. Timer for completion of the forced compensation pops up and the status of the device changes
Note: Before enabling the Force compensation, the reference CO2 concentration needs to be
determined.
Sampling time configuration [s]:
The customer can set the sampling rate of the sensors via the slider box or by typing directly into the text box as
shown in figure 11. After changing the related settings press enter and click the "Apply all settings" button from
the bottom left corner of the screen as shown in Figure 10.
Note: Changes in the Sampling time is global for all devices
Figure 12 Sampling time configuration [s]:
User manual 11 of 14 V 1.3
2024-03-01