Setting Vcare Settings In Service Mode - Konica Minolta bizhub PRESS C6000 Setup Instructions

12. Set dipswitch 15 bit 0 to Off(0).
13. Press Return Close twice Exit twice then Cycle Power.
Note: Cycle power by turning off SW2 and SW1. Wait 15 seconds before powering on
the MFP. Then wait until the MFP comes to a full ready
G: Setting vCare settings in Service Mode
1. Press Utility\Counter -> Stop -> 00 -> Stop -> 01 to enter Service Mode.
2. Select [CS Remote Care].
3. Select [CS Remote Care].
Konica Minolta bizhub PRESS C6000/C7000/C8000/C70hc Main Body bizhub vCare HTTP Setup Guide
Page 7 of 21