Adjustments - Weider PLATINUM XP600 User Manual

ADJUSTMENTS
This section explains how to adjust the resistance system, See the EXERCISE GUiDELiNES on page 20 for
important information about how to get the most benefit from your exercise program, Also, see the accompany-
ing exercise guide to see the correct form for each exercise,
Make sure all parts are properly tightened each time the resistance system is used, Replace worn parts immedio
ately, The resistance system can be cbaned with a damp cloth and a mild, non-abrasive detergent, Do not use
solvents, The resistance bar can be cbaned with a vinyl and rubber protectant, availabb at an automotive or
department store,
ATTACHING THE HIGH PULLEYS
To use a high pulley, slide the hook on the High
Pulley Housing (52) onto the Eyebolt (51), Attach the
end of the Short Cable (60) without the ball to the end
of the long cable (C) with a Cable Clip (64), Attach
the other high pultey in the same manner.
Remove the high putteys when not in use.
ADJUSTING THE SEAT
The Seat (41) can be secured in any of four positions
on the Bench Rail (23), To move the Seat, pull the
Seat Knob (43) out as far as it will go, and slide the
Seat to the desired position, Engage the Seat Knob
into an adjustment hob in the Bench Rail, Note: It
may be necessary to !ift up on the Seat in order to
engage the Seat Knob.
To perform row exercises, the hip strap must be
attached to the long cable (see ATTACHING THE
ACCESSORIES on page 16), and the Seat Carriage
(48) must be able to roll along the Bench Rail (23),
First, remove the Backrest (40) from the Seat
Carriage (see ADJUSTING THE BACKREST on page
17), Then, pull the Seat Knob (43) out as far as it will
go, and turn the Knob so that the pin rests at the end
of the "L'oshaped slot (see the inset drawing),
15
51 ,
i
C
41
23
48
Pin
43