Radio Mode Operations.16 - Clarion VRX8271 Owner's Manual And Installation Manual

Radio Mode Operations
FM Reception
For enhanced FM performance the mnGITUNEn®
tuner includes signal actuated stereo control,
Enchanced Multi AGC, Impulse noise reduction
curcuits and Multipath noise reduction circuits.
Listening to the radio
1) Press the FUNC button [7] to select radio
mode.
2) Press the BAND button i 8] to select a band.
Each time you press the BAND button
(JO,
the band changes in the following order:
—► FM2 —► FM3 —►
3) Press one of the preset buttons S to tune in
to a station.
Preset memory function
A total of 24 stations can be preset, 6 each for
the FM1, FM2, FM3, and AM bands.
Note:
• When a station is preset, the station previously
stored in the memory at that position is cleared.
Manual memory function
1) Press the BAND button 18 to select a band.
2) Slide the Up/Down button 3 to ► (right) or
A (left) to tune in to a station.
3) Press and hold for about 2 seconds one of
the Preset buttons .3 where you want to
store the station. When a beep sounds, the
station is stored in that button.
*One station in each band can be preset to
each button.
Seek tuning
1
) While iMANUl appears in the display, press
and hold the BAND button GO for about 1
second to switch to the seek tuning.
2) Slide the Up/Down button
}T)
to ► (right) or
A (left) to start the seek tuning. When a sta¬
tion is found, it is automatically tuned in.
► : Seeks higher frequency stations.
A : Seeks lower frequency stations.
*To stop the seek tuning, slide the Up/Down
button CD to ◄ (left) or ► (right).
Manual tuning
1
) When IMANUl does not appear in the display,
press and hold the BAND button [sj for about
1
second to select manual tuning.
*When manual tuning is selected, IMANUl
appears in the display.
2) Slide the Up/Down button 13 to ► (right) or
A (left) to tune in to a station.
* Each time you slide the Up/Down button 3,
the frequency changes in 0.2 MHz increments
for the FM and in 10 kHz increments for the
AM band.
* Press and hold the Up/Down button 3 to ►
(right) and A (left) to increase or decrease
the frequency continuously.
Auto store function
Note:
• This function is not available when the display is
stored.
1) Press the BAND button [8j to select a band.
2) Press the DISP button Ro] to select PS/AS
mode.
* Press the DISP button Qo) again to return to
preset mode.
3) When PS/AS mode is displayed, press No. 2
of the Preset buttons
|T|.
Stations with good
reception are automatically stored in preset
buttons starting from Preset button g]. (After
storing 6 stations, preset No. 1 station is
tuned in and auto storing ends.)
* I A-s I in the display becomes pink.
* Stations with good reception are stored in the
order from the current station to stations with a
higher frequency. If there are fewer than 6 sta¬
tions with good reception, the auto storing returns
to the lowest frequency and resumes from there.
Note:
• When stations are preset by the auto store func¬
tion, the station previously stored in the memory
at that position is cleared. If there are fewer than
6 stations with good reception, the stations previ¬
ously stored at the remaining preset buttons are
not cleared.
16