Clarion VRX8271 Owner's Manual And Installation Manual page 12

Tuner/5-inch color lc display with cd changer/ dsp/eq control
Hide thumbs Also See for VRX8271:
Table of Contents

Advertisement

3) To store the Display BU in the source unit, turn it
to the horizontal position until a click is heard.
* The display will be stored and the power to the
source unit will be turned off automatically.
Be careful not to let your fingers get caught
when storing the panel.
Mounting and detaching the operation panel
The operation panel of this unit is detachable to
prevent theft (DCP mechanism).
1
) Move the DCP Lever S to the right. The
operation panel is unlocked and comes out.
* The power is turned off at the same time.
2)
Pull the top edge of the Operation Panel
(HI
to remove it.
After removing the panel,
put it in the attached DCP
4P*
case for Drotection.
3)
To mount the Operation Panel
El,
insert the
panel's lower edge into the display edge and
push the panel's upper edge until a click is
heard.
* Press the FUNC button (3 to turn on the
power.
* Do not give an excessive force to the opera¬
tion panel. Even after the operation panel is
installed and locked, pulling it forcefully acti¬
vates the sensor of the DCP and turns off the
power to the unit, or may cause a breakdown.
Turning on and off the monitor
Each time you press the MON I button 0, the
monitor is turned on and off.
*When a button other than the volume adjustment
button is pressed or during rear vision monitoring,
the monitor-off mode is canceled.
Mute
Each time you press ►/!! (center) of the ENT
button [Tj, mute is turned on and off.
"MUTE" is displayed when mute is turned on in
radio mode, and ''PAUSE" is displayed in CD
changer mode.
Adjusting the tone
Notes:
• When the DSP or equalizer unit (DPH9100,
DPH7100, or EQH5100) sold separately is
connected to the source unit, the tone is
adjusted by the DSP or equalizer unit and the
tone adjustment mode cannot be selected. For
further information, see the section "Operating
the DSP and Equalizer."
• If no operation is made for about 5 seconds
after each operation, the unit returns to the
previous mode and the settings made are
stored.
1) Press the AM button dj to 9° t0 the ,one
adjustment mode.
■ ■■ TONE
■ /L.
«► BASS
riiiiP rfjQQi
pfitritodi tti'KrfBKl
U
nrnni imm
n
riYTiiiniT i iran
LJ
Banal w
* BA (bass) and TR (treble) are displayed in the
information panel
jT:.
13

Advertisement

Table of Contents
loading

Table of Contents