Clarion VRX8271 Owner's Manual And Installation Manual page 13

2) Slide the Up/Down button [T! to 4 (left), ►
(right), ▲ (up), or ▼ (down) to adjust the
tone.
^ (left) : Bass is attenuated.
► (right) : Bass is emphasized.
A (up) : Treble is emphasized.
▼ (down): Treble is attenuated.
3) Press the AM button [3] to return to the pre¬
vious mode.
Adjusting the balance
Note:
• If no operation is made for about 5 seconds after
each operation, the unit returns to the previous
mode and the settings made are stored.
1) Press the AM button [3] to go to the tone
adjustment mode.
2) When the tone adjustment mode is dis¬
played, press the following buttons to switch
to the balance adjustment mode.
When the display is open: Press^/ll (cen¬
ter) of the ENT button Q].
When the display is closed: Press the AM
button [3].
* BL (balance of right and left speakers) and FD
(fader: balance of front and rear speakers) are
displayed in the Information Panel L11.
— Balance of the front
I and rear speakers
L Balance of the left
and right speakers
3) Slide the Up/Down button [fj to A (left), ►
(right), A (up), or ▼ (down) to adjust the
balance of the speakers.
◄ : Increases the volume of the left speaker.
► : Increases the volume of the right speaker.
A : Increases the volume of the front speaker.
▼ : Increases the volume of the rear speaker.
Loudness
Notes:
• When the DSP or equalizer unit (DPH7100 or
EQH5100) sold separately is connected to the
source unit, the loudness effect cannot be select¬
ed.
• When the DSP unit DPH9100 sold separately is
connected to the source unit, loudness cannot be
adjusted. See the subsection "Setting the auto
loudness effect" (page 28) to adjust loudness.
Press the LD button '3j for about 1 second. The
loudness effect turns on and off.
*When the loudness effect is turned on, "LD"
appears in the display.
14