Basic Operations.12 - Clarion VRX8271 Owner's Manual And Installation Manual

Basic Operations
Note: Be sure to read this chapter referring to the front diaarams of
chapter ''2. CONTROLS" on page 5 (spread).
When this unit is turned on, starting and stop¬
ping the engine of a car with its volume raised
to the maximum level may harm your hearing.
Be careful about adjusting the volume.
NOTE: Use this unit after starting the engine.
Turning on the power and adjusting
the volume
1) After turning the car's ignition switch on and
starting the engine, press the POWER button
0
to turn on the power to the unit.
* This unit starts in the mode it was in when the
power was turned off last.
2) Press the FUNC button 0 to select the oper¬
ation mode.
Each time you press the FUNC button 0,
the operation mode changes as follows:
▼
CD changer mode
Radio mode (When the CD changer is connected)
I_}
* Press and hold the FUNC button [7] for about
one second to turn off the power.
3) Slide the Up/Down button 0 to A (up) or
▼ (down) to adjust the volume.
A : Increases the volume.
T : Decreases the volume.
* The volume level indicated is in the display in
a range from 0 (minimum) to 33 (maximum).
Note:
• In the CONFIGURATION or BALANCE display,
the volume cannot be adjusted.
f
• .
While driving, keep the volume to a level at
which external sounds can be heard.
A WARNING
THIS PRODUCT IS NOT INTENDED FOR
VIEWING TELEVISION BROADCASTS OR
VIDEO TAPES OR FOR PLAYING VIDEO
GAMES. Such uses of this product may
distract the driver or interfere with the dri¬
ver's safe operation of the motor vehicle
and may violate state law. CLARION DIS¬
CLAIMS ANY LIABILITY FOR ANY BODILY
INJURY, INCLUDING FATALITIES, OR
PROPERTY DAMAGE THAT MAY RESULT
FROM ANY SUCH UNINTENDED USES OR
FROM ANY IMPROPER USE OF THIS
PRODUCT.
Opening and turning the display
1) Press the OPEN button 0 to open the
Display M-
Notes:
• Do not place any object on the open display.
• Do not drop any object on the movable part.
• Do not expose the display to shocks.
• If the display is left horizontally in the open posi¬
tion for 10 seconds or longer, it is automatically
drawn in.
2) Turn the display upwards to a good viewing
angle.
When the display is turned upwards, a pic¬
ture appears. Information panel display dis¬
appears.
Label
t;r~-Turn the display \^JI Its
upwards by holding only
the front edge from the label.
Do not turn the display unless it is complete¬
ly open.
When adjusting the angle of the display, be
careful not to let your fingers get caught by
the panel or instrument panel of the vehicle.
Do not hold the part of the display beyond
the label (see the illustration above).
12