8 Piping installation
In this chapter
8.1 Preparing piping
8.1.1 Circuit requirements
EWSAH/X06UD
Daikin Altherma 3 WS
4P675765-1 - 2022.04
8.1
Preparing piping......................................................................................................................................................................
8.1.1
Circuit requirements ..............................................................................................................................................
8.1.2
8.1.3
8.1.4
8.2
8.2.1
8.2.2
8.2.3
8.2.4
8.2.5
8.3
Connecting water piping ........................................................................................................................................................
8.3.1
8.3.2
8.3.3
To connect the water piping..................................................................................................................................
8.3.4
8.3.5
8.3.6
8.3.7
8.3.8
To check for water leaks ........................................................................................................................................
8.3.9
To insulate the water piping ..................................................................................................................................
NOTICE
All piping MUST be installed according to section G3 of the Building Regulations.
INFORMATION
Also read the precautions and requirements in the
4
precautions" [
NOTICE
In case of plastic pipes, make sure they are fully oxygen diffusion tight according to
DIN 4726. The diffusion of oxygen into the piping can lead to excessive corrosion.
▪
Circuit types. Except for the refrigerant circuit, inside the unit 2 other circuits are
included:
-
The circuit connected to the common pump and the water source or outdoor
unit is referred to as the central water loop.
-
The circuit connected to the heating emitters is referred to as the space
heating circuit.
▪
Connecting piping - Legislation. Make all piping connections in accordance with
the applicable legislation and the instructions in the "Installation" chapter,
respecting the water inlet and outlet.
▪
Connecting piping - Force. Do NOT use excessive force when connecting the
piping. Deformation of the piping can cause malfunctioning of the unit.
10].
8
Piping installation
|
"2 General safety
Installer reference guide
71
71
75
76
77
77
77
77
78
79
79
79
79
80
80
81
84
84
85
85
85
71