Reset To Factory Settings - EWM drive 4X HP Operating Instructions Manual

Display

5.10.1.1 Reset to factory settings

All special parameters saved by the user will be overwritten by the factory settings!
Operating
element
099-005392-EW501
01.02.2016
Setting/selection
Predefined absolute value for relative programs
Start program (P ), down-slope program (P
START
relative to the main program (P
0 = Relative parameter setting (ex factory)
1 = Absolute parameter setting
Electronic gas flow control, type
1 = type A (ex works)
0 = type B
Program settings for relative programs
0 = Combined setting of relative programs possible (ex works).
1 = Individual setting of relative programs possible (ex works).
Correction or nominal voltage display
0 = Correction voltage display (ex works).
1 = Absolute nominal voltage display.
Action Result
Switch off welding machine
Keep the button pressed
Switch on welding machine
Release the button, wait about 3 seconds
Switch off welding machine and restart in order to put the changes into
effect
Design and function
Special parameters (advanced settings)
) and end program (P
B
) or in an absolute manner, as desired.
A
) can be set
END
87