Reset To Factory Settings - EWM Phoenix Expert drive 4L M3.70 Operating Instructions Manual

Display

5.12.2 Reset to factory settings

All special parameters saved by the user will be overwritten by the factory settings!
Operating
element
099-004846-EW501
8.01.2014
Setting/selection
Predefined execution of the pulsed arc welding process in the PA program
1 = If the superPuls and welding process switching functions are available and
activated, the pulsed arc welding process is always executed in the main
program PA (ex factory).
0 = Predefined execution of the pulsed arc welding process in the PA program is
disabled.
Predefined absolute value for relative programs
Start program (P ), down-slope program (P
START
relative to the main program (P
0 = Relative parameter setting (ex factory)
1 = Absolute parameter setting
Action Result
Switch off welding machine
Keep the button pressed
Switch on welding machine
Release the button, wait about 3 seconds
Switch off welding machine and restart in order to put the changes into
effect
Design and function
Special parameters (advanced settings)
) and end program (P
B
) or in an absolute manner, as desired.
A
NOTE
) can be set
END
67