Machine Control - Operating Elements - EWM drive 4X HP Operating Instructions Manual

Machine description – quick overview
Machine control – Operating elements
Machine control – Operating elements
4.4
Item Symbol
1
2
3
4
5
20
Description 0
Functional sequence - See 4.4.1 Functional sequence chapter
Push-button, welding task selection (JOB)
SP1/2/3 Special JOBs (Phoenix Expert only). Pressing the push-button longer: special
JOB selection. Pressing the push-button briefly: switching between special
JOBs.
Select the welding task using the welding task list (JOB-LIST)) (not applicable
JOB-LIST
for Phoenix Expert). The list can be found inside the protective cap of the wire
feed mechanism and in the appendix to these operating instructions.
Display, left
Welding current, material thickness, wire speed, hold values
Push-button, parameter selection left/power-saving mode
AMP Welding current
Material thickness
Wire feed speed
Hold After welding, the values used last are shown from the main program. The
signal light is illuminated.
STBY Press for 2 s to put machine into power-saving mode.
To reactivate, activate one of the operating elements.
Display, JOB
Shows the currently selected welding task (JOB number). Phoenix Expert machines will
display the special JOB selected (SP1, 2 or 3), if applicable.
Figure 4-4
099-005392-EW501
01.02.2016