Remove And Install The Chassis; Remove The Chassis - Kuhl - Friedrich Kuhl KCS12B10A Service Manual

REMOVE AND INSTALL THE CHASSIS

Remove The Chassis - Kuhl

Figure 501 (Chassis Removal and Installation)
Support Bracket
Figure 502 (Support Bracket)
48
Use Handle
Locations
(both sides)
FAR RIGHT
SCREW
CAUTION
ENTRYGARD
1.
Remove the decorative front cover.
RETAINER
WIRE
Maintenance Figure 401.
2. Remove the chassis Entrygard Retainer Wire by removing
the screw at the front right bottom corner. Save this screw
for reattachment after reinstalling the chassis. See Figure
501.
3. Hold the cabinet stationary then use the hand grips on both
ends of the control unit support bracket to pull the chassis out
of the cabinet .
Do not push, pull,
or lift from
center of support
WARNING
ELECTRIC SHOCK HAZARD
Disconnect power to the unit before
servicing. Failure to follow this warning
could result in serious injury or death.
See Routine