Remove and Install Front Cover -Kuhl
Remove the decorative front cover.
1. Using a 1/4" nut driver loosen the four (4) captive screws as shown in figure 401
Install the decorative front cover.
1. Tighten the four (4) captive screws as indicated by the arrows in the figure above before closing the front panel (do not over tighten).
Ensure the filter is in place. Make sure curtains do not block the side air intake
2. Notes on reattaching the decorative front cover:
Align the cord notch over the cord and center the fresh air lever.
Align the cover over the User Interface (UI) to ensure it is clear around it and it does not depress any buttons. If not installed correctly
the wrench alert symbol could flash.
41
ROUTINE MAINTENANCE
WARNING
ELECTRIC SHOCK HAZARD
Disconnect power to the unit before
servicing. Failure to follow this warning
could result in serious injury or death.
B
Figure 401 (Remove and Install the Front Cover)