Mercedes-Benz CLE Coupe 2023 Owner's Manual page 676

674 Technical data
ACEA C5 (only engine oils of viscosity
class SAE 0W-20 in each case)
Vehicles with diesel engines: MB-Freigabe or
MB-Approval 229.51 or ACEA C3
Missing values were not available at the time of
going to press.
Engine oil filling quantity
Model
CLE 200 4MATIC
CLE 450 4MATIC
All other models
The specified filling quantity refers to an oil
change with the oil filter.
Notes on brake fluid
Observe the notes on operating fluids
( page 667).
/
& WARNING Risk of an accident due to
vapour pockets forming in the brake sys-
tem
The brake fluid constantly absorbs moisture
from the air. This lowers the boiling point of
the brake fluid. If the boiling point is too low,
vapour pockets may form in the brake system
when the brakes are applied hard.
This impairs the braking effect.
Quantity
Have the brake fluid renewed at the
#
specified intervals.
Have the brake fluid regularly replaced at a quali-
6.0 litres
fied specialist workshop.
Only use a brake fluid approved by Mercedes-
Benz according to MB-Freigabe or MB-Approval
331.0.
Coolant
▌Notes on coolant
Observe the notes on operating fluids
( page 667).
/
F236 0017 02
& WARNING Risk of fire‑ and injury from
antifreeze
If antifreeze comes into contact with hot com-
ponent parts in the engine compartment, it
may ignite.
Allow the engine to cool down before
#
you top up the antifreeze.
Make sure that no antifreeze spills out
#
next to the filler opening.
Thoroughly clean the antifreeze from
#
component parts before starting the
vehicle.
* NOTE Damage caused by incorrect cool-
ant
Only use coolant that has been premixed
#
with the required antifreeze protection.
Information on coolant is available at the fol-
lowing locations:
In the Mercedes-Benz Specification for
R
Operating Fluids 320.1