Mercedes-Benz CLE Coupe 2023 Owner's Manual page 554

552 Wheels and tyres
Tighten the wheel bolts evenly in a diagonal
#
pattern in the order indicated until they are
finger-tight.
Unscrew and remove the centring pin.
#
Tighten the last wheel bolt until it is finger-
#
tight.
Lower the vehicle ( page 552).
/
#
Lowering the vehicle after a wheel change
Requirements
The new wheel has been fitted (
R
* NOTE Risk of the jack becoming trapped
due to the rear axle level control
If the rear axle level control has released air
when raising the vehicle, the jack can become
trapped when the vehicle is lowered.
Start the engine. This adapts the vehicle
#
level.
Remove the jack from under the vehicle.
#
To lower the vehicle: place the ratchet onto
#
the hexagon nut of the jack so that the letters
"AB" are visible and turn anti-clockwise.
page 551).
/
F236 0017 02
Tighten the wheel bolts evenly in a diagonal
#
pattern in the order indicated
an initial maximum force of 80 Nm.
Tighten the wheel bolts evenly in a diagonal
#
pattern in the order indicated
the specified tightening torque of 130 Nm.
& WARNING Risk of accident due to incor-
rect tightening torque
The wheels could come loose if the wheel
bolts or wheel nuts are not tightened to the
prescribed torque.
Ensure that the wheel bolts or wheel
#
nuts are tightened to the prescribed
tightening torque.
If you are not sure, do not move the vehi-
#
cle. Contact a qualified specialist work-
shop and have the tightening torque
checked immediately.
Check the tyre pressure of the newly fitted
#
wheel and adjust it if necessary.
1 to 5 with
1 5
to with