Mercedes-Benz CLE Coupe 2023 Owner's Manual page 48

Quick start and Tips
46
* NOTE Damage to components of the vehi-
cle body or chassis due to fitted snow
chains
If you fit snow chains to the front wheels of
4MATIC vehicles, you may damage compo-
nents of the vehicle body or chassis.
Only fit snow chains to the rear wheels
#
of 4MATIC vehicles.
Observe the following notes when using snow
chains:
Snow chains are only permissible for certain
R
wheel/tyre combinations. You can obtain
information about this from a Mercedes-Benz
Service Centre.
For safety reasons, only use snow chains that
R
have been specifically approved for your vehi-
cle by Mercedes-Benz, or snow chains with
the same quality standard.
Comply with the installation instructions of the
R
snow chain manufacturer.
If snow chains are fitted, the maximum per-
R
missible speed is 50 km/h.
Vehicles with Active Parking Assist: do not use
R
Active Parking Assist when snow chains are
fitted.
%
You can permanently limit the maximum
speed for driving with winter tyres
( page 272).
/
%
®
You can deactivate ESP to pull away
( page 265). This allows the wheels to spin,
/
achieving an increased driving force.
Notes on windscreen washer fluid
Observe the notes on operating fluids
( page 667).
/
& WARNING ‑ Risk of fire and injury due to
windscreen washer concentrate
Windscreen washer concentrate is highly flam-
mable. It could ignite if it comes into contact
with hot engine component parts or the
exhaust system.
F236 0017 02
Make sure that no windscreen washer
#
concentrate spills out next to the filler
opening.
* NOTE Damage to the exterior lighting due
to unsuitable windscreen washer fluid
Unsuitable windscreen washer fluids may
damage the plastic surface of the exterior
lighting.
Only use windscreen washer fluids which
#
are also suitable for use on plastic surfa-
ces, e.g. MB SummerFit or MB WinterFit.
* NOTE Blocked spray nozzles caused by
mixing windscreen washer fluids
Do not mix MB SummerFit and MB Win-
#
terFit with other windscreen washer flu-
ids.
Do not use distilled or de-ionised water. Other-
wise, the fill level sensor may be triggered errone-
ously.