Caution; Operational Temperature & Humidity; Dot Defect (Dead Pixel) Of Tft - ViewZ VZ-IPM Series User Manual

12262023-Rev. A
SAFETY INSTRUCTION
Important Safety Instruction

Caution

• If the connector between the plug and the pin is dusty or dirty, clean it properly using a dry cloth.
• Make sure to unplug the power cord before cleaning the monitor.
• Make sure to leave a gap between monitor and wall.
• Do not drop the monitor when moving it.
• Place your monitor in a location with low humidity and a minimum dust.
• Install the monitor base on a showcase or shelf so that the end of the base does not protrude from the
showcase or shelf.
• Do not place the monitor on an unstable or small surface area.
• Do not install inside a vehicle.
• Disconnect the plug from the outlet during storms or lightning or if it has not been used for a long time.
• Do not try to move the monitor by pulling on the power cord.
• Do not cover the vents on the monitor.
• When moving the monitor, turn off and unplug the power cord. Make sure that all cables, including HDMI
cable and cables connected to other devices, are disconnected before moving it.
• Place the monitor out of children's reach, as they could damage it by hanging onto it.
Available Temperature & Humidity
Operating Temperature : 14°F ~ 122°F / -10°C ~ 50°C
•
• Operating Humidity : 20 ~ 70% RH

Dot Defect (dead pixel) of TFT

ViewZ monitors are manufactured using high-end semiconductor technology with precision ratings of 99.9%
and above. However, it may be the case that certain RGB and white pixels seem darker (or entirely unlit i.e.
black).
Modern production methods cannot guarantee an absolute fault-free monitor. To this effect, no LED
manufacturer can guarantee a defect free panel. A few isolated pixel or sub-pixel faults are considered
tolerable and different policies exist that govern the amount of these tolerable values.
While most pixel faults occur in isolated regions, a cluster of dead pixels or sub-pixels can sometimes form for
which a separate ruling applies. A cluster is defined as an area of 5x5 pixels. ViewZ's policy on pixel failure:
either as an isolated fault or in the form of a cluster is outlined on the website: www.viewzusa.com
User Manual Visit the ViewZ USA website at https://www.viewzusa.com 5