7.4
MAIN POWER BATTERY CHARGING WITH AC/DC ADAPTOR
(Regular/Normal Charge)
When the PDT shows the "Main battery low" message or icon, the battery pack in the WDT2200
needs to be recharged. Plug one end of an AC-9VDC/1Amp power adapter into the DC-jack of
RS232 cable and the other end into a wall outlet. The battery pack will be fully recharged after 2-3
hours.
The WDT2200's CR2032 Lithium backup battery is not rechargable.
7.5
MAIN BATTERY CHARGING WITH CRADLE
Connect power adapter to the cradle and insert the WDT2200. The battery of PDT can be fully charged in
about 2~3 hours and the status of battery charging is indicated by the LED on the front panel of the cradle.
The LED will be red when charging and green when the main battery is fully charged, ready for use.
© 2003 Wasp Technologies, Inc.
Page 41 of 41