Wasp WDT2200 Operation Manual page 24

wait on
keyin/scan
OR
call INT 22H
♦Active
♦Stand by
♦Shut Down In Shutdown mode, the main power is cut off from the WDT2200
NOTE: To conserve battery power, keep the WDT2200 in
3.2.3.6 Password Definition
This function is used to create a password. The password is used to
prevent an unauthorized user from entering the Supervisor mode and
accidentally changing the WDT2200 configuration parameters. The
Password may consist of maximum ten (10) alphanumeric characters
( A - Z , 0 - 9 ). The Default password is "2200".
At the User Mode menu:
1. Press 6 (6.PSWD)
2. Enter the new password
3. Press [ENT] to change the Password
program running POWER
ON
press [PWR]
(switch off)
ACTIVE
key in
bar code scan
RS232 input
Auto-off timeout
STAND
BY
press [PWR] (switch off)
All system hardware is activated in Active mode. The system will
enter Stand-by mode if it waits on input or call INT 22H.
In the Stand-by mode, if a key is depressed, a bar code or RS-232
input occurs the WDT2200 will return to Active mode. Otherwise,
the portable terminal will enter Shutdown mode if the WDT2200 has
been idle for the specified timeout period as set in
excluding its RAM and Real Time Clock.
while waiting for input.
© 2003 Wasp Technologies, Inc.
press [PWR]
(switch on)
SHUT
DOWN
NMI
POWER
FAILURE
OLD PASSWORD:
2200
NEW PASSWORD:
Page 24 of 41
.
AUTO OFF
mode
STAND BY