Table of Contents
Advertisement
______________________________________________________
3.2.2.8
SET
The SET command allows the user to set system date-time, select type of bar
<SYSTEM SETUP>
code scanner, assign laser module scanning method, enable double
1.DATE & TIME
2.SCANNER
verification and specify whether to enable the power-on logo. Select the
3.DISPLAY
corresponding number, 1 through 4, to invoke a function. Pressing the [CMD]
4.KEYPAD
and then the [Alpha] key returns the portable terminal to the User Mode
5.EXIT
menu.
3.2.2.8.1
DATE & TIME Set System Clock/Calendar
By selecting "1.DATE & TIME" in the SET menu, you can set the WDT2200 date and time. The
date and time can be used as the time stamp to be appended to an input data record by an application
program. The second line shows the current system date in the format YYYY/MM/DD
(year/month/day). For instance, 1998/01/01 indicates that date is January 1, 1996. If you want to
reset the system date to August 31, 1997, then enter [1],[9],[9],[7],[0],[8],[3],[1] or press the [ENT]
key to skip the system date setting.
The third line shows the current time. The setting method is similar to setting the date. The time is
expressed in the 24-hour format using HH:MM:SS (hours:minutes:seconds).
3.2.2.8.2
SCANNER
SCANNER
The bar code input interface of the WDT2200 is compatible with all major bar
code scanners that are available in the market including wand, CCD and laser
diode scanners. Use the [ ] key to toggle among ENABLE and DISABLE,
then press [ENT].
LASER TRIG MODE : The user can select whether the pen is activate to read barcode label
by one trigger/one scan or by flash scan. If it is set to NORMAL, the laser beam
will be emitted to scan a barcode and will stop upon reading the barcode
successfully. The user needs to release the trigger key and then press again to
scan next label. If it is set to FLASH, the user just presses the trigger and then
releases it, then the scanner will automatically scan the barcode. When it
successfully reads a barcode, the scanner will continue to emit a laser beam to
read the next label. The user can press trigger again to stop automatic scanning.
LASER AIM When WDT2200 is equipped with SE1200LR engine, user can use this setting to
activate aim beam before starting scanning barcode. It will be helpful for user to
focus on a target barcode label. Use the [ ] key to toggle between ENABLE
and DISABLE, then press [ENT].
VERIFICATION Poor label quality can cause decoding errors. You can enable this function to
let the WDT2200 double verify bar code input. When it is set to ENABLE, the
WDT2200 reads barcode labels twice, comparing the data before sending it.
© 2003 Wasp Technologies, Inc.
Page 15 of 41
Advertisement
Table of Contents
