Wasp WDT2200 Operation Manual page 23

WDT2200 FormCaching Defaults
The WDT2200 enables FormCaching. By default, the following settings apply:
DATA FIELD DEFINITION: field number=2
Category
Field #1 FIELD PROMPT
DATA LENGTH
DATA TYPE
DEVICE TYPE
Field #2 FIELD PROMPT
DATA LENGTH
DATA TYPE
DEVICE TYPE
DATA RECORD DEFINITION
Category
BETWEEN FIELD
FIELD DELIMITER
RECORD FELIMITER
DATE STAMP FIELD
TIME STAMP FIELD
FIELD DELAY
3.2.3.5 POWER or ON-OFF
The WDT2200 provides system power on/off feature.
1.)RESUME, 2.)AUTO OFF, or 3.)ALARM
1.RESUME When the Resume function is enabled, the WDT2200 will resume program
execution from the last turn-off point when it is again powered on. The default
setting is ON (enabled).
1. Press 1 (1.RESUME)
2. At the STATUS SETUP Menu, use the [ ] key to select between
RESUME ON (enable Recovery) and RESUME OFF (disable recovery)
3. Press [ENT] to complete the setting
2.AUTO OFF Use the [ ] key to set the auto-off timeout from 1 to 9 minutes. The WDT2200
will turn itself off automatically after being idle for the time period specified in the
AUTO OFF
feature is disabled when set to 0 minutes.
A smart power management system is built into the WDT2200 hardware and
software to conserve battery power. The WDT2200 power transition flow is as
follows:
Setting
ITEM:
32
ALPHANUM
BOTH
QTY:
4
NUMERIC
KEY ONLY
Setting
Append screen
,
CR
NONE
NONE
0
setting. The default setting of
© 2003 Wasp Technologies, Inc.
Once 5 is selected, user can define
is 5 minutes. The auto-off
AUTO OFF
Page 23 of 41