3.2.3 Supervisor Mode
The WDT2200 Supervisor mode allows the user to configure and validate the WDT2200
hardware. To switch the WDT2200 to the Supervisor mode of operation do the following:
1. Turn off the WDT2200.
2. Press and hold down the [CMD] and [ ] keys simultaneously, then switch on the WDT2200
by pressing the power key. The WDT2200 LCD will show the 'START MENU" where the user
has three choices: 1.Enter the Supervisor mode, 2.Command the WDT2200 to execute a Warm
Start, or 3. Command the WDT2200 to execute a Cold Start.
password entry is requested from the user to prevent unauthorized users from
After selecting 1, a
accidentally changing configuration parameters. The system will return to the Ready mode after 5
unsuccessful tries. The default password is "2200". The Supervisor mode menu will be shown on
the LCD after the correct password is keyed-in.
The Supervisor Mode function lets the user set the following functions:
1. DEV:
Device Configuration
2. TERM:
Terminal Configuration
3. MEM:
Memory Configuration
4. FORM:
FormCaching Define
5. PWR:
Set Resume/Auto-Off/Alarm of program
6. PSWD:
Password Change
7. SYS:
System Initialization, update BIOS
8. DIAG:
System Diagnostic
3.2.3.1
Device Configuration
<DEVICE CONFIG>
1.KEYPAD
2.SERIAL
3.BARCODE
1.KEYPAD
The WDT2200 supports several international language setting.
language setting is ENGLISH. Press [ ] or [ ] to select a different language
setting from Sweden/Finland, Danish, Spanish, Franch, German, or Italian. Press
[ENT] to confirm the setting and return to the previous menu.
When selecting the option "1.DEVICE", the LCD will offer the user 3
choices: 1) Set the keypad input Language setting, 2) Set the serial port
communication parameters, and 3) Enable/disable supported bar code
symbologies.
© 2003 Wasp Technologies, Inc.
Page 17 of 41
The default