7.3
MAIN/BACKUP BATTERY REPLACEMENT AND INSTALLATION
Main Battery
1. Make sure the unit is turned off.
2. Turn the unit face down. Turn the locking screw counterclockwise ¼ turn.
3. Remove the main battery pack from the battery compartment. Do not disturb the backup
battery in the lower compartment or all data will be lost!
4. Insert a new main battery pack and replace the cover.
Lithium Back up Battery
1. Remove the main battery, as above, then remove the backup battery cover and the backup
battery itself.
2. Insert a new CR2032 Lithium battery into the backup battery holder with correct orientation.
3. Insert the main battery pack, replace the cover and tighten the screw.
Back up your PDT data replacing the Lithium backup battery!
© 2003 Wasp Technologies, Inc.
Page 40 of 41