Replacing Right Sealing Ring - Skoda Fabia III 2015 Workshop Manual

Fabia III 2015 ➤, Kamiq 2019 ➤, Karoq 2018 ➤, Karoq 2020 ➤, Octavia III 2013 ➤, ...
Automatic gearbox 09G - Edition 02.2021
Installing
Installation is carried out in the reverse order. Pay attention to
the following:
• Coat the outer circumference and sealing lips of the new
sealing ring with ATF before installation.
• Fitting position: The open side of the sealing ring faces to‐
wards the gearbox.
– Position new seal ring by hand and press in as far as possi‐
ble, so that the shaft seal is fixed in the gearbox housing.
– Position pressure plate -T10176- in the middle on the shaft
seal -A-.
– Drive the new gasket ring up to the stop in the pressure
plate; do not tilt the gasket ring.
– Install left drive shaft ⇒ Running gear, axles, steering; Rep.
gr. 40; Drive shaft; Removing and installing drive shaft.
– Inspecting ATF level and if necessary topping up
level", page 23 .
– Install the noise insulation ⇒ General body repairs, exterior;
Rep. gr. 66; Noise insulation.
1.2

Replacing right sealing ring

Gasket ring can be replaced with the gearbox installed.
Special tools and workshop equipment required
222
Rep. gr.39 - Final drive - differential
⇒ A2.1 TF