Table of Contents
Advertisement
Hold the Right Upright
(76) against
the Base
(74).
Be careful
not to pinch
the wires,
Partially
tighten three 3/8" x 3 1/4" Screws
(2)
with three 3t8" Star Washers
(3) into the Right
Upright
and the Base; do not fully
tighten
the
Screws
yet.
With the help of a second
person,
tip the
treadmill
onto its right side.
Press in a Base
Cap (not shown)
and attach
the Left Upright
(not shown)
as described
in steps 3 and 5,
Note: There are no wires on the left side.
6,
Identify the Left and Right Handrails
(59, 64),
which are marked
"Left" and URight." Remove
the
four 5f16" x 3/4" Screws
(5) and four 5/16" Star
Washers (6) from the bottoms
and sides of each
Handrail,
Hold the Right Handrail
(64) near the Right
Upright (76). Insert the wire tie on the Upright
Wire {63) through the hole in the bottom
and
out of the hole in the side of the Left Handrail as
shown.
Then, pull the Upright Wire through the
Right Handrail.
Attach
the Right Handrail
(64) to the Right
Upright
(76) with fwo of the 5/16" x 3f4" Screws
(5) and two of the 3/8" Star Washers (6) that
you just removed.
Make sure
not to pinch the
Upright
Wire (63), Start
both Screws,
and
then tighten
them.
Attach
the Left Handrail
(59) to the Left Upright
(66) as described
above.
Note: There are no
wires on the left side,
59
Advertisement
Table of Contents
